The Printer Doctor - For this afternoon's post the printer doctor will share how to overcome Canon Printer Results Uneven / Broken, this case often occurs in Canon printers and other printers that use encoders (horizontal / vertical line sensors). If you are a fan of Canon printers then this method is very necessary for you to understand, with you knowing this method of course you will benefit with you will be more economical in terms of operational costs. When your printer when the printing process is ugly, not good, broken or maybe zigzag, then I suggest not to rush to sentence that the damage is on the cartridge, then you decide to buy a new cartridge or a new printer, why? Because for bad results there are many factors that cause it and among the most frequent is because the sensor is dirty with ink or the lines are lost due to wear. If it turns out this sensor damage alone causes the printer results to be less good you will be more economical in terms of funds. Okay, right ...
INITIAL INDICATION:
When we use the printer to test print the resulting print is not straight, broken and piling up, as shown below.
HOW TO OVERCOME :
- Open the printer cover carefully, the printer doctor recommends that it be on the camera first if it has never been unloaded, so that later it is not wrong or there is something missing in assembling it again.
- Observe the ENCODER (the sensor band made of plastic with the bar code on the surface) that is located transversely in the direction of the movement of the cartridge house.
- Clean the encoder is usually dirty with splashed ink, REMEMBER be careful in cleaning it, do not get the lines of broken lines or replace the encoder with a new one.
- If we have replaced the encoder sensor but the results are still ugly, it means the damage is already on the head of the cartridge, the solution is to replace the new cartridge.
So a little post from the printer doctor, hopefully useful, THANK YOU .... :)