Wednesday, March 30, 2016

HOW TO RESET CANON MG2170, MG2270, and MG5270 ERROR P07 and E08

Unknown March 30, 2016 Add Comment

Afternoon friend Doctor Printer, for this time the printer doctor will share about How to Reset Canon Printer with Printer Series MG2170, MG2270 and MG5270 with indication error P07 or E08, If you are user of this printer and currently experiencing error problem above, then do not worry here I will love the trick how to overcome it. before it is necessary for us to know the cause so that we can get the right medicine. OK just go ahead ...

PRELIMINARY INDICATIONS:

When we turn on the canon printer MG2170, MG2270 or MG5270, then on the screen / LCD will display the description "The Ink Absorber is Almost Full" and on the LCD Fanel screen printer will appear error P07 / E08.

See the picture below

HOW TO RESET:

Turn on the Canon MG2170, MG2270 and MG5270 printers, then on the LCD panel will appear error message P07 or E08, and there will be information "The Ink Absorber is Almost Full" on your monitor screen or LCD.
Donwload Resetter Here
Before the reset The printer must be in SERVICE MODE.
How to SERVICE MODE Printer, Turn off the printer by pressing the power button. REMEMBER DO NOT IN BRINGING THE CABLE POWER.
In the Printer position is off and the power cable is still stuck in the printer, press the STOP / RESET button followed by pressing the POWER button, so both buttons are still depressed.
Release the STOP / RESET button but do not release the POWER button.
In case POWER button is still depressed, press the STOP / RESET button for 5 TIMES.
Then release both buttons simultaneously, then the position of your MG printer is in SERVICE MODE.
LCD panel MG2170, MG2270 and Mg5270 will be blank / dark and on Computer / Laptop printer doctor friend will detect new Hardware, Then Ignore it ....
Next step, Extract and run the Software resetternya, by following the steps illustrated images below.
Prepare two papers for the reset process.
Click MAIN then Click set like picture below then printer will print one page with the words "D = 000.0".
Click Step number 3 which is click the main then step into 4 sets then click step to 5 printer will print again one page with one of his writing "TPAGE (TTL = 00000)".
After that turn off the printer, then turn the printer back on.
Printer is ready to print money again ..... (ha ha ha ....: D)