As-salamu'alaikum, good afternoon printer doctor friend all, for this time the printer doctor will share about how to solve the print out of canon printer is not perfect or not full, before the printer doctor wrote this article, this morning printer doctors arrival patients a mother- mother came at the printer doctor's workshop, complained his printer is again in trouble with ink does not come out, said the printer owner's mother 'Mas like this, my printer was out I fill the ink but really can not make print ya ..., the result is empty mas, but I fill it up full lho until no longer fit '.
Then the printers I check the print results are top empty but the middle to bottom there is even though not perfect as shown below. If the sendainya printer doctor friend experienced the exact same thing as the case above, you do not need to be confused.
The above case occurs due to over charging ink / so the cartridge blobor / flood due to too much pressure and finally can not be controlled by the cartridge itself, see the picture below as an example of the cause of the above problem
To overcome this is very easy, that is with us reduce the contents of the ink catrid by sucking, can from the top or bottom, then wipe with head surface tissue to clean, then re-install the cartridge and please try to test print, Insha Allah will succeed , this way physicians have practiced printer practice in physician printer workshop and succeed.
So little that I can ignore on this daytime kesempata hopefully can be useful for physician friend printer all of them, and I say good luck .... :)